BORETTI BRV82 Instrukcja Użytkownika Pobierz pdf (Strona 17)

Care and cleaning

Caution! Unplug the appliance before

carrying out any maintenance operation.

This appliance contains hydrocarbons in

its cooling unit; maintenance and re-

charging must therefore only be carried

out by authorized technicians.

Periodic cleaning

The equipment has to be cleaned regularly:

• clean the inside and accessories with

warm water and bicarbonate of soda (5 ml

to 0,5 liter of water)

• regularly check the door seals and wipe

clean to ensure they are clean and free

from debris

• rinse and dry thoroughly.

Important! Do not pull, move or damage any

pipes and/or cables inside the cabinet.

Never use detergents, abrasive powders,

highly perfumed cleaning products or wax

polishes to clean the interior as this will dam-

age the surface and leave a strong odour.

Once a year remove the ventilation grill at the

base of the appliance and clean the air chan-

nels with a vacuum cleaner. This operation

will improve the performance of the appli-

ance and save electricity consumption.

Caution! Take care of not to damage

the cooling system.

Many proprietary kitchen surface cleaners

contain chemicals that can attack/damage

the plastics used in this appliance. For this

reason it is recommended that the outer cas-

ing of this appliance is only cleaned with

warm water with a little washing-up liquid

added.

After cleaning, reconnect the equipment to

the mains supply.

Defrosting of the refrigerator

Frost is automatically eliminated from the

evaporator of the refrigerator compartment

every time the motor compressor stops, dur-

ing normal use. The defrost water drains out

through a trough into a special container at

the back of the appliance, over the motor

compressor, where it evaporates.

It is important to periodically clean the defrost

water drain hole (F) situated under the salad

drawers to prevent the water overflowing and

dripping onto the food inside. Use the special

cleaner provided (P), which you will find al-

ready inserted into the drain hole.

P

F

Defrosting the freezer

A certain amount of frost will always form

around the top compartment.

Important! Defrost the freezer when the

frost layer reaches a thickness of about 3-5

mm.

To remove the frost, do these steps:

1. Switch off the appliance.

2. Remove any stored food, wrap it in sev-

eral layers of newspaper and put it in a

cool place.

3. Open the door.

4. When defrosting is completed, dry the in-

terior thoroughly.

5. Switch on the appliance.

6. Set the temperature regulator to obtain

the maximum coldness and run the ap-

pliance for two or three hours using this

setting.

7. Reload the previously removed food into

the compartment.

17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Komentarze do niniejszej Instrukcji

Brak uwag